Sink Stopper Won T Seal

A sink stopper mechanism isn t difficult to understand.

Sink stopper won t seal.

The culprit is often a buildup of hair around the base of the stopper or the pivot rod mechanism. It moves the stopper in the opposite direction to the lift rod. Click here for maintenance and service parts. Remove stopper from drain.

Water may leak or refuse to drain around a sink pop up for a number of reasons. 5 shows the gasket pushed out of position. Simply remove the plunger clean and if necessary replace. 6 shows the gasket seated correctly between the clicker assembly and the stopper.

Re tighten the thumb screw by turning clockwise. A pivot rod that connects to the back of the drain pipe a perforated strap a clevis and a screw that locks the strap onto the stopper rod. Fix a sink stopper. The ball rod is inserted into the side of the drain and attached with a nut.

Unthread the sink stopper s tailpipe from the underside of the drain. When you push or pull on the lift rod it activates a lever the extends through the drain tailpiece. A sink stopper with a push pull rod control at the faucet is a great modern convenience. How to fix a sink pop up drain stopper.

The gasket located under the stopper may also need to be adjusted. To reach the stopper the ball rod needs to be removed first. Remove clip from ball rod. The lever hooks onto the stopper through a hole or hook on the bottom of a long plastic flange that s attached to the stopper.

This is a repair you can do yourself. Now that the bottom of the tailpipe if free from the p trap loosen the nut that connects it to the threaded bottom of the sink drain. The photo on the right fig. If a sink won t hold water look up behind the sink with a flashlight if needed to identify the following parts.

The photo on the left fig. It s easy to fix a bathroom sink drain plug that s leaking. The clicker may have been over tightened causing the. Gasket to push outward.

To remove unthread the rod nut pull the ball rod out and remove the stopper from the drain. Most sink stopper tailpipes are made of pvc and will be connected to the drain with a pvc compression nut that you can loosen by hand. But sink stoppers fail. If water still does not hold in the sink the next check will be the actual stopper seal.

The ball rod holds the stopper in the drain. Peek above the sink to make sure the stopper is fully closed and that the pop up rod is pushed all the way down 3.